top of page

Call Us Today! 920.541.7621

Tacos & Tapas Restaurant

We were called upon during the rough in inspection process to start this Chapel Hill restaurant project. The electrical inspection would not be passed until the low voltage wiring was installed. We were able to come in immediately and install all of the data cabling for the point of sale terminals and printers well as install a 14 camera IP video surveillance system.

Every project starts with a good plan.

Time to get going!

Wires being pulled through the drop ceiling.

Organizing and strapping wiring to the open ceiling structure.

Bundling wiring is often the safest way to prevent damage by other tradespeople during the rough in process.

POS terminal wiring inside the main office.

IP cameras are beginning to go in.

These cameras will keep an eye on the line and exposition areas of the kitchen.

Sometimes you encounter insteresting mounting conditions for equipment. We'll get it where it needs to be.

Dome camera discreetly watches over the enterance and host station.

No conduit sleeves were provided during rough in, so we had to drill through the concrete and brick for all exterior camera locations.

Back kitchen door will be covered by this bullet camera.

POS system wiring trimmed out behind the bar.

Data cabling installed under the concrete floor into floor boxes to serve the host stand and pager stations.

Exterior bullet camera on the front canopy surveys the main enterance to the restaurant.

EMT conduit installed on the canopy to the camera location. When this is painted to match the canopy it will blend right in with the industrial feel of the construction!

Bullet camera keeps and eye on the walk in freezer. Bullet cameras are the best choice for harsh conditions.

Another exterior bullet camera watching the outdoor patio area.

POS Terminals Installed!

Printers on Kitchen Line

Finished Camera Install with Wall Mounted Viewing Monitor.

bottom of page